Efento Cloud October update 2019/10/14
We are really glad to inform you, that new update of Efento Cloud is now available. The update is automatically available to all of the users and without extra charges.
Important changes are:
- Possibility of the swap of sensors
- Notifying of the low SMS status
- Change of the way of adding sensors
Thanks of the update concerning the swap of sensors, the user can freely exchange loggers without the data loss and in compliance with the continuity of current measurements e.g. in case of periodic calibrating of the sensor. The swap of the logger takes place from the level menu of the configuration. The user is choosing the sensor which is supposed to be changed and from the list of new is choosing the device which is supposed to be added into its place. Measuring data and the configuration (alarm rules, automatic reports) of swapped sensor are staying kept, and the new sensor is beginning the data transfer. Information about the swap is staying written in system logs.
It is not necessary to buy an additional licence to swap the logger.
Notifying of the low SMS status
Thanks to this revision administrators of the organization are being informed of the low SMS status. When the number of available SMS will fall below 15, automatically notifications will be sent e-mail to all administrators of the organization along with information about the current SMS balance. Notifications are included automatically and cannot be turned off.
Change of the way of adding sensors
A way of adding new sensors was also changed. So far the license key was assigned to each of sensors. After the update, the key is being assigned for the organization and enables to add the specific number of sensors. This solution causes, that adding many sensors at once is fast and comfortable. Additionally is possible to change loggers inside the organization until achieving the determined by the license numbers of sensors.
- Adding the location in alerts
- Adding the location in rules
- Removing shortened names of the location (3 part code of the organization)
Adding the location in rules
A tree of the location, allowing for fast and simple filtering out the alarm rules concerning the chosen location turned up at the bookmark of the Rule. Thanks to that choosing the location e.g. Cracow we will see all alarm rules concerning sensors assigned to Cracow, not visible are remaining alarm rules. It allows for comfortable grouping rules, peculiarly in large organisations.
Adding the column “Location “in alerts
In the bookmark Alerts we have added the filtration after the specific localization appeared. Thanks to that in the simple and comfortable way it is possible to see alerts concerning sensors in the chosen location.